Craftsman 247.88976 series Operator's Manual page 14

Pro series
Hide thumbs Also See for 247.88976 series:
Table of Contents

Advertisement

Available languages

Available languages

NOTE: Chute control rod will fit snug into pinion gear. Support rear of dash
panel with one hand while inserting rod with your other hand to ensure rod
is inserted
into pinion gear.
all the way
NOTE: The hole in the chute directional control rod is a reference for aligning
rod with indicator arrow on pinion gear, and will be visible after rod has been
inserted.
7.
Push chute control rod toward control panel until hole in rod lines up with
hole in chute control input closest to chute control head and insert hairpin
clip (a)removed in Step 1. See Figure 25.
NOTE: Second hole is used to achieve further engagement of chute control
rod into pinion gear if required. Refer to Service section for Chute Control
Rod adjustments.
8.
Finish securing chute control head to chute support bracket with wing nut,
clevis pin, and bow-tie cotter pin (e) removed in Step 1.
Continue to Set-Up (page 18).
Figure 24
Figure 25
STOP
ASSEMBLY
Overhead Chute Control (w/ Flex Shaft & Steel Chute)
1.
Remove lock nuts and hex screws from chute support bracket (this will
require two wrenches). See Figure 27.
2.
Place chute assembly onto chute base and chute control head onto chute
support bracket. See Figure 27.
Chute
Assembly
14
Figure 26
Chute Control
Head
Chute
Support
Bracket
Chute Base
Figure 27

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents