Configuring The Lindy Cpu Switch Junior Osd - Lindy 32 277 Installation And Use Manual

5 LINDY CPU Switch Junior OSD Configuration
Options
IMPORTANT NOTE
This next section is for configuration of the LINDY CPU Switch Junior OSD 4 and 8 ports
For configuration of non-OSD models please refer to section 4.
5.1

Configuring the LINDY CPU Switch Junior OSD

The LINDY CPU Switch Junior OSD is supplied pre-configured with factory defaults which are
suitable for most applications. There are a number of more advanced options which can be set by
the user. These are stored in the LINDY CPU Switch Junior OSD's EEPROM memory and are
retained when the power is disconnected.
The options may be changed whilst the LINDY CPU Switch Junior OSD is in configure mode. You
may enter configure mode at initial power on or whilst the LINDY CPU Switch Junior OSD is
running.
To enter configure mode at power on, switch off all the attached PCs and the LINDY CPU Switch.
Hold down the front panel key whilst powering on the LINDY CPU Switch. Remember that the
LINDY CPU Switch Junior draws its power from any attached PC via the keyboard cable and so
will power itself on when the attached PC is switched on or when the optional power adaptor is
connected. Do not release the key until the LINDY CPU Switch displays 'C' to show that it has
entered configure mode.
To enter configure mode whilst the LINDY CPU Switch is running, hold down the front panel key
for 5 seconds until the front panel display shows 'C'.
Options are entered by typing a letter followed by a number followed by <ENTER>. Use <ESC> to
abort the entry of an option. The LINDY CPU Switch will remain in configure mode until you type
<ENTER>.
For example: to set hotkey option 2 type the following at the 'C' prompt
(at LINDY CPU Switch 'C' prompt) <ENTER>
To exit configure mode type: <ENTER>
Page 24 Installation & Use – English Guide LINDY ELECTRONICS LTD