Advertisement
Available languages
Available languages
the rubber mat. The mounting holes have to be
facing the front.
• Insert the 2 mounting pins fully in the 2
mounting holes (14)
• Use the brackets to clamp the machine onto
the table.
• Tighten the clamp with the wing nuts, by hand.
Make sure to tighten the machine properly, but
do not over tighten.
• Make sure the machine is totally secure before
switching the machine on.
The machine can be set to continuous operation
by using the blocking switch (8)
4. SERVICE AND MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
1. The electromotor gets hot
• The cool ventilation slots in the motor are
stopped up with dirt.
• Clean the cool ventilation slots.
• The motor is defect.
• Please contact the service address on the
warranty card.
2. The connected machine does not work
• Interruption in the mains connection.
• Check mains connection for fracture.
• Please contact the service address on the
warranty card.
3. The dust is not absorbed
• This can be caused by a stopped up dust
extraction
• Clean your dust collection opening
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove stubborn dirt using
a soft cloth, dampened with soapy water. Do not
use solvents such as benzene, alcohol, ammonia,
etc, which might damage the plastic parts.
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is
an exhaustive overview of the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off
at recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
7
Advertisement
