Connecting The Cable - Fujitsu ASG30LMTA Service Instruction

8-1-3. Connecting the cable

(1) Use the following cables (locally purchased) for this connection.
22AWG Sheathed PVC
cable Polar 3 core
(2) Attach the cable to the terminal block.
Position the wires so that the number on the terminal match.
(3) Install the cable as shown in the photograph below.
Be sure to place the wiring under the tabs.
(4) Fix the cable with the cable clamper and screw as shown in the photograph mentioned above.
(Front view)
Red
White
Tab
• Do not connect the cable to the terminal for power supply.
• Make sure to insulate the connecting parts when extending the cable.
8-1-4. Front panel, control box cover replacement
Reinstall by reversing the procedure in "8-1-1 Front panel, control box cover removal"
(1) Replace the control box cover (2 screws).
(2) Open a hole in the front panel for the remote
controller cable to pass through.
* Choose from 4 knockout holes marked on
the inside of the front panel.
(3) Replace the front cover.
First, insert the hook on the lower part of the
front panel (5 places), then fit the hooks on
the top (3 places).
(4) Replace the 10 screws.
(5) Replace the wire cover (1 screw).
(6) Replace the 4 caps.
(7) Replace the intake grille.
AMP Air Conditioning
Cable size Remarks
Use shielded cable in
accordance with local
rules for cable.
(Right view)
Black
Screw
Screw
CAUTION
Cut
Knockout holes
Top holes (3 places)
Middle hooks
Indoor unit
(5 places)
Intake grill installation
c
01-29
www.ampair.co.uk | sales@ampair.co.uk
Cable clamper and screw
Cable
Front panel
Knockout holes
Top hooks
(3 places)
Front panel
Middle hooks
(5 places)
Press down on 4 places.