Husqvarna 525L Workshop Manual page 29

Repair instructions
Fit the spark plug cap onto the ignition cable and
make sure the ends of the wire is inserted into the
centre of the spark plug cap for best contact.
TIP!
Lubricate the hole in the spark plug guard using for
instance silicon spray to make it easier to push the
ignition coil in.
Still no spark?
Check other cables and connections for poor contacts
(dirt, corrosion, cable breakage and damaged insulation).
Make sure that the cables are correctly drawn and lie in
the cable grooves.
Do not forget to check the cables in the handle.
TIP!
Use an Ohmmeter in order to easily check if
cable breakage has occurred, due to pinching, for
example.
Still no spark?
Change ignition module.
Disconnect the cables from the ignition module.
Remove the two screws holding the ignition
module.
29
English -