Replacing The Presser Foot - Brother 888-M00 Operation Manual

Replacing the Presser Foot

CAUTION
• Use the appropriate presser foot for the type
of stitch that you wish to sew, otherwise the
needle may hit the presser foot, causing the
needle to bend or break. For details on the
presser foot that should be used with the
selected stitch, refer to "Stitch Chart" on
page 35.
• Only use presser feet designed specifically for
this machine. Use of any other presser foot
may result in injuries or damage to the
machine.
Note
• When a stitch is selected, the icon for the presser foot
that should be used appears in the screen. Check that
the correct presser foot is attached before starting to
sew. If the wrong presser foot is installed, attach the
appropriate presser foot. (page 10)
Replacing the presser foot
a Press (Needle position button) once or twice to
raise the needle.
b Press .
 The screen changes, and all keys and operation
buttons are locked (except
CAUTION
• When replacing the presser foot, be sure to
press on the operation panel to lock all
keys and buttons, otherwise injuries may occur
if the "Start/Stop" button or any other button
is pressed and the machine starts.
c
d
e
1
f
g
).
h
Replacing the Presser Foot
Raise the presser foot lever.
Press the black button at the back of the presser foot
holder in order to remove the presser foot.
1 Black button
a
2 Presser foot holder
Place the appropriate presser foot below the presser
foot holder so that the presser foot pin is aligned with
the notch in the holder.
1 Presser foot holder
2 Notch
3 Pin
4 Presser foot type
4
2
J
3
Slowly lower the presser foot lever so that the presser
foot pin snaps into the notch in the presser foot holder.
a
1 Presser foot lever
2 Presser foot holder
3 Notch
4 Pin
 The presser foot is attached.
Raise the presser foot lever to check that the presser
foot is securely attached.
Press to unlock all keys and buttons.
c
23
1