Initial Settings Adjusting Initial Settings; Setting The Time; Switching The Warning Tone - Pioneer Premier DEH-P640 Operation Manual

Initial Settings
Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press and hold until the unit turns
SOURCE
off.
2 Press and hold until time
FUNCTION
appears in the display.
3 Press to select one of the initial
FUNCTION
settings.
Press repeatedly to switch between
FUNCTION
the following settings:
— —
CLOCK WARN AUX
TEL
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down until the unit turns off.
FUNCTION

Setting the time

This is used to set the time on the unit's clock
display.
1 Press to select the
FUNCTION
Press until the time appears in the
FUNCTION
display.
— — —
DIM BRIGHT SW
.
BAND/ESC
.
CLOCK
2 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.

Switching the warning tone

If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
—
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select
WARN
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
Warning :ON
to select .
WARN
repeatedly until
Warning
on or off with 5/∞.
between on
Warning
Section
07
33
En