Troubleshooting - Whirlpool AMD 302 User Manual

Table of Contents

Advertisement

TROUBLESHOOTING

Operation problems are often due to minor causes that can be found and fixed without
using any tools:
Trouble
Does not run
No cooling or heating air
Ineffective control
Does not operate
immediately
Peculiar smell
A sound of running water
Cracking sound
Mist sprays from the outlet
After switching off, the flap
appears not to close fully.
Indoor unit fan stops during
heating.
If you find any of the following symptoms, please turn the circuit breaker off immediately
and call the authorized service centre nearest to you for help.
• The power supply cable is abnormally hot or damaged.
• The appliance makes abnormal sounds during operation.
• The safety breaker, fuse or earth leakage breaker often cuts off operation.
• Some switch or button repeatedly fails to work normally.
• The air conditioner produces a burning smell during operation.
• Water leaks from the indoor unit.
Downloaded from AC-Manual.com Manuals
• Is the protection device or fuse blown?
• Please wait for 3 minutes and start again, protection device may be
preventing unit to work.
• Are the RC batteries low?
• Is the plug not properly plugged?
• Is the air filter dirty?
• Are the intakes and outlets of the air conditioner blocked?
• Is the temperature set properly?
• Has there been a strong interference (from excessive static electricity
discharge, power supply voltage abnormality)? Note that operation will
be abnormal, in this case unplug from the power supply and re-plug after
2-3 seconds.
• 3 minute delay will occur when changing mode during operation.
• This smell may come from another source such as furniture, cigarette
etc, which is sucked in the unit and blown out with the air.
• Normal behaviour caused by the flow of refrigerant in the air
conditioner.
• Defrosting sound in heating mode.
• The sound may be generated by the expansion or contraction of the
front panel due to temperature changes.
• Mist is present in the room with low temperature? Normal behaviour
due to cool air discharged from indoor unit during COOLING or DRY
operation mode.
• The stepping motor could not find the RESET point. Restart the air
conditioner and then stop it again.
• The air conditioner is de-icing, which takes 10 minutes at most. (It
freezes when the outdoor temperature is very low and humidity is high).
It automatically resumes operation after approximately 10 minutes.
12
Analysis

Advertisement

Table of Contents
loading

Table of Contents