Notes For Moving And Transporting; Notes For Installation; Removing The Door - LG GS-L668PNL Owner's Manual

Notes for Moving and
Transporting
• Remove all food from inside the appliance.
Then, transport the appliance only after fixing
fragile parts such as shelves and the door
handle with tape. Failure to do so may cause
appliance damage.
• Pull the power plug out, insert and fix it into the
power plug hook at the rear or on top of the
appliance. Failure to do so may cause damage
to the power plug or floor scratch.
• When transporting the appliance, more than two
people should transport the appliance carefully.
Dropping the appliance, which is extremely
heavy, may cause personal injury or appliance
failure.
• When transporting the appliance over a long
distance, keep the appliance upright. The
appliance may fall over, causing malfunctions.
Never transport the appliance laying down as it
can cause a refrigerant circulation malfunction
when it is turned back on again.
12

Notes for Installation

• Install the appliance on a solid and flat area.
– If the appliance is installed on an uneven
floor, it can cause vibration and noise
causing the appliance to fall resulting in
injury. It could also cause the doors not to
close correctly and introduce moisture inside
the unit during operation.
– If the appliance front or rear is not level,
adjust the front feet so that it can be
corrected. Severe cases may need the floor
to be packed out with strips of thin timber.
• Avoid placing the unit near heat sources, direct
sunlight or moisture.
• Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances on
the same outlet.
• After connecting the power supply cord (or plug)
to the outlet, Wait two or three hours before
you put food into the appliance. If you add food
before the appliance has cooled completely,
your food may spoil.
• Models with handles should be located at least
55 mm from the wall on the hinge side to open
door by 90°.
• Allow over 55 mm clearance to the right, left,
back and top when installing.

Removing the Door

When it is necessary to move the appliance
through a narrow opening, removing the doors is
the recommended procedure.
WARNING
• Disconnect the power cord, house fuse or
circuit breaker before installing or service the
appliance. Failure to follow these instructions
may result in death, fire or electric shock.
If your entrance door is too narrow for the
appliance to pass through, remove the appliance
doors and pass the appliance laterally.