Table of Contents
Advertisement
To log in to the Web interface:
1. Use an Ethernet cable to connect the PC or the configuration terminal to an
Ethernet port on the device.
2. Assign the login host an IP address in the same subnet as the device.
3. Open the browser, and then enter login information:
In the address bar, enter the IP address of the device.
a.
−
HTTP access—http://ip-address
−
HTTPS access—https://ip-address
The ip-address argument represents the IP address of the device.
On the login page, enter the default username (admin) and leave blank the
b.
password line. You do not need to enter a password at the first login.
Click Login.
c.
For more information about how to Telnet CLI, see HPE FlexNetwork NJ5000 5G
PoE+ Walljack Switch Getting Started Guide.
Install the device on a network without a DHCP Server and
configure the device from its Web interface or Telnet CLI
1. Use an Ethernet cable to connect the PC or the configuration terminal to an
Ethernet port on the device.
2. Identify the IP address and mask of the device.
If the device is not connected to the network, or no DHCP server exists on the
network, the device uses the default IP address and mask. The default mask is
255.255.0.0. The default IP address is 169.254.xxx.xxx, where xxx.xxx depends
on the last two bytes of the MAC address. Find the MAC address label on the
device and use the following rules to determine the last two bytes for the IP
address:
Last two bytes of the MAC address
All 0s
All Fs
Not all 0s or all Fs
For example:
Last two bytes for the IP address
0.1
255.1
Decimal values of the last two bytes
of the MAC address
12
Advertisement
Table of Contents
