Table of Contents
Advertisement
12
Safety Instruction
The manufacturer can not be held liable for damages caused by improper use or abuse, lack of
reasonable care, or manipulations contrary to the recommendations given in this manual.
Do not open the reader! There are several spots inside the device, where high voltage is
generated during the scanning process.
The ARE H9 Reader does not contain any parts to be repaired by the user. Any attempt to open
the reader may damage the device. Therefore it may be repaired only by authorized personal.
Environmental conditions, as given in section 10, have to be observed during storage and
operation.
Protect the USB interface socket against dirt, moisture and dust.
For cleaning of the reader and cable use a moistened towel. Never use chemical solvents like
e.g. acetone.
Do not submerge the reader in water.
13
FCC Information
Federal Communications Commissions (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user's authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-
Consult the dealer or an experienced radio/TV technician for help.
---------------------------------------------------------------35/36-------------------------------------------------------------
Advertisement
Table of Contents
