Download  Print this page

Norman ML600 Monolight Instruction Manual

Norman ml600 monolight instruction manual
Hide thumbs
   

Advertisement

Instruction
ML600 Monolight
Manual
INTRODUCTION
Welcome to the Norman family of interchangeable high-quality flash equipment and thank
you for purchasing a Norman Monolight system. The utilization of larger high-duty-cycle
flash capacitors and related components enables this system to be utilized for demanding
commercial and portrait silver halide and digital applications that are not normally associated
with monolights.
FEATURES
o
600 watt-second capacity. The ML600 is an honest 600 watt-seconds (1500 w-s by
today's advertising)
o
1/20-stop repeatability at full power. Holds this tolerance with line voltages from 105
to 125 volts.
250 watt quartz modeling lamp with fan cooling.
o
Digital controls with LED display. Adjustable in 1/10-stop increments.
o
Error condition diagnostic readouts via internal software, as displayed in the LED
o
arrays (page 7).
Automatic thermal protection (page 7).
o
Interchangeable with over 100 Norman accessories and light modifiers with adapter
o
ring (part no. R9113).
o
Full two year limited warranty, including parts and labor.
2

Advertisement

Table of Contents
loading

  Related Manuals for Norman ML600 Monolight

No related manuals

  Summary of Contents for Norman ML600 Monolight

  • Page 1 Instruction Manual ML600 Monolight INTRODUCTION Welcome to the Norman family of interchangeable high-quality flash equipment and thank you for purchasing a Norman Monolight system. The utilization of larger high-duty-cycle flash capacitors and related components enables this system to be utilized for demanding commercial and portrait silver halide and digital applications that are not normally associated with monolights.
  • Page 2 IMPORTANT SAFEGUARDS In accordance with UL122 specifications for photographic equipment. When using your photographic equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions. 2. Care must be taken as burns could occur from touching the flashtube or modeling lamp.
  • Page 3 CONTROL PANEL / OUTLETS / BASIC OPERATION AC Power Inlet Connects to the AC power cable. The AC input is 115 volts, 60 Hz. The unit is voltage stabilized to provide 1/20-stop full power repeatability with AC line voltage fluctuations of 20 volts (105-125 volts).
  • Page 4: Specifications

    ADVANCED OPERATION Alarm System In the event of a misfire the LED display will blink bFL (see page 7). The alarm system is reset automatically by flashing the unit or by pressing any button on the control panel. Thermal Protection The ML600 is protected with an internal overtemp cutout.