Table of Contents
Advertisement
WIT-400H User Manual
Issue: 0.1A
SSID
SSID is used as an ID meaning by "I am a member of family" in 802.11b compliant wireless network. The WIT-
400H should have the same SSID to one configured within an AP(Access Point). For setup SSID, please refer to
subsection 6.5.4. About SSID in your office, you should contact network administrator.
5.0.2
MFIM setup
MFIM IP address
WIT-400H should know the IP address of MFIM to initially request registration. For setup of MFIM IP address
please refer to subsection 6.5.5.
Network mask
Since MFIM of IPECS resides in wired network, network mask should be specified as well. For setup of MFIM
network mask, please refer to subsection 6.5.5.
5.0.3
Rebooting WIT-400H
After the proper setup of both wireless LAN and MFIM IP address, just turn off the phone and turn it on. The WIT-
400H will start registration and show its station number which is given by MFIM.
5.1
Basic Feature
User can use various telephone features with a WIT-400H registered to MFIM module in an
5.1.1
Turing the Power On and Off
Turning the Phone On
When pressing [END] (
The following describes the sequence of power-on:
1. Install a charged battery pack
2. Press for a few seconds until the blue light in the right upper of the phone is on and off.
3. WIT-400H shows power-on animation
3. WIT-400H tries to do locking the access point while blinking Antenna Icon and RSSI level.
4. If Antenna Icon and RSSI level stop blinking, it means all procedures for initial setup are completed.
5. WIT-400H searches MFIM and sends a registration message to MFIM.
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG-Nortel Co.Ltd
) button, the power is turned on and the WIT-400H goes to an idle state.
20
Date: 28/July/2009
iPECS
system.
Advertisement
Table of Contents
