Table of Contents
Advertisement
Installing and Configuring the
802.11b and 11g AP Cards
The 802.11b and 11g AP Cards can be installed only in HP ProCurve Wireless
Access Point 520wl. To setup your 520wl, please see the documentation that
came with that product.
Installing an AP Card
1. Slide the card into Slot A or B.
2. Connect the HP 520wl unit to a power source. (Cards can be installed
when the 520wl is powered on.)
3. Wait for the power LED on the card to turn green before proceeding.
Figure 5. Installing an AP Card
4. Complete the basic configuration of the card, as described under
"Configuring the Basic Items" on the next page.
Radio Antenna Notes:
The built-in radio and antennas of the 802.11b and 11g AP Cards
■
perform best in an open environment with as few obstacles as
possible.
■
To achieve the maximum range for wireless communications, do not
cover the card with objects such as books or thick stacks of paper.
If you are using the card in a non-open location, you may consider
■
the purchase and use of the optional HP ProCurve Range Extender
Antenna 100wl, which can be connected to either card. See the HP
ProCurve website for other available HP ProCurve antennas.
www.hp.com/go/hpprocurve
6
1
2
3
Advertisement
Table of Contents
