Troubleshooting - Electrolux EHH3320NVK User Manual

• Remove shiny metallic
discoloration: use a solution of water

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or op‐
erate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up func‐
tion does not operate.
with vinegar and clean the glass
surface with a moist cloth.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper‐
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time.
The zone is hot.
ENGLISH
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor
field.
Refer to "Daily use" chap‐
ter.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
31