Table of Contents
Advertisement
Changing the wakeup settings
1. Tap
> Settings > Personal tab > Wakeup Source icon.
turn on the device's power. Pressing any one of the function buttons on
the front panel wakes up the device.
3. Tap ok when done.
Changing the USB settings
To change the USB settings:
1. Tap
> Settings > Connections tab > USB Settings icon.
•
Transmission as Network Interface
a network card so that you can connect it to a PC to browse the
Internet, etc.
•
Transmission as Serial Interface - allows a serial connection
between your device and PC. Select this when using ActiveSync.
•
Simulation as Card Reader - turns your device into a mass
storage unit similar to a card reader.
•
Simulation as Flash Disk - turns your device into a mass storage
800MB for map storage and more.
3. Tap ok when done.
To change the USB charging mode:
1. Tap USB Charger tab from the USB Settings screen.
•
Slow Charging - to use this mode, your PC needs to support 100mA.
•
Fast Charging - to use this mode, your PC needs to support 500mA.
3. Tap ok when done.
NOTE
To avoid overcharge, charging automatically stops after 5
hours. In Fast Charging mode, the device is able to be fully
charged within 5 hours, but in Slow Charging mode, it is
neccessary to connect the device again to the power source
to get it fully charged.
26
Chapter 2
Advertisement
Table of Contents
