Related Manuals for Philips Manufactured Housing Vinyl Window
Summary of Contents for Philips Manufactured Housing Vinyl Window
- Page 1 PRODUCTS NSTALLATION HILIPS RODUCTS HONE UMBER 574/296-0000 ANUFACTURED INYL INDOW NSTRUCTIONS EXCLUDES STORM WINDOWS OUSING -1610 3/05...
- Page 2 ERFORMANCE OF THIS MPROPER NSTALLATION WILL OID THE These instructions are for Philips Products, Inc. vinyl windows only. LEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE WINDOW These instructions represent an acceptable installation method. Other methods may be acceptable. Determining the acceptability of alternate installation methods is the sole responsibility of the housing manufacturer.
- Page 3 Inspect the outer frame for damage. If frame is cracked, fractured, or damaged due to handling, contact Philips Products, Inc. for instructions. Inspect the mounting flanges to ensure they have not been damaged or distorted during shipping or handling to the extent that they will not seat flat against the exterior perimeter of the R.O.
-
Page 4: Window Installation
INDOW NSTALLATION Place the window in the R.O. with the window sill resting on the R.O. sill. If the R.O. sill is not square to the floor and if you have elected to shim the window, then place shims beneath the low corner of the unit until the sill of the unit is square. -
Page 5: Optional Installation
Cleaning – Do not use abrasive cleaners on the glass as they may perma- nently scratch or mar the surface. Any cleaners, other than a mild deter- gent and soft cloth, should be tried in a small corner of the window so as to check whether they damage the finish. - Page 6 ASEMENT INDOW INGE DJUSTMENT HESE PROCEDURES ARE TO BE USED ONLY IF THE WINDOW NEEDS FUTURE ADJUSTING The amount of sash that this hinge will compensate for is dependant on the ratio of the sash width vs. sash height. To calculate the amount of sash drag adjustment for any given window size, take the ratio of width to height multiplied by 1/16”.