Canon iPF720 Service Manual page 42

Ipf700 series
Hide thumbs Also See for iPF720:
Table of Contents

Advertisement

Chapter 1
[Interface Setup]
[EOP Timer]
[EOP Timer]
[NetWare]
[AppleTalk]
[Ethernet Driver]
[Ext.Interface]
[Init. Settings]
[Maintenance]
Setting Item
[Maint. cart.]
[Replace P.head]
[Repl. S. Cleaner]
[Change Cutter]
[Move Printer]
1-28
Setting Item
[TCP/IP]
[IP Mode]
[Protocol]
[DHCP]
[BOOTP]
[RARP]
[IP Setting]
[IP Address]
[Subnet Mask]
[Default G/W]
[NetWare]
[Frame Type]
[Print Service]
[Auto Detect]
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
When exchanging the maintenance cartridge, choose Yes and follow the instructions on the screen.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is low.
When replacing the Printhead , choose Yes and follow the instructions on the screen.
When replacing the shaft cleaner, select [Yes] and take appropriate actions according to the instructions
shown on the screen.
When replacing the cutter unit, select [Yes] and take appropriate actions according to the instructions shown
on the screen. Replacing the cutter unit will reset the cut count.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is low.
When transferring the printer to another location, choose Yes and follow the instructions on the screen.
T-1-17
Description, Instructions
Specify the timeout period for print jobs.
Specify the TCP/IP protocol settings. To apply your changes, choose Store
Setting .
Choose whether the printer IP address is configured automatically or a static IP
address is entered manually.
Specify the protocol used to configure the IP address automatically.
Specify the printer network information when using a static IP address.
Enter the IP address assigned to the printer, as well as the network subnet mask
and default gateway.
Specify the NetWare protocol. To apply your changes, choose Store Setting .
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your changes, choose
Store Setting .
Specify the communication method. To apply your changes, choose Store
Setting .
Choose On for automatic configuration of the LAN communication protocol.
Choose Off to use settings values of Comm.Mode and Ethernet Type .
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the LAN.
Displays the MAC address.
When installing the expansion interface board, choose whether the expansion
interface board is used.
A confirmation message is displayed if you press the
to restore the network settings to the default values.
T-1-18
Description, Instructions
button. Choose [OK]

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents