Brake belt contact surface ���������������������������������� 13 Chain 1/2“ x 1/8“ ������������������������������������������������� 14 Freewheel sprocket ��������������������������������������������� 15 Spare parts list ��������������������������������������������� 16 Important Read the manual carefully before using the cycle and save it for future use. 2016 MONARK EXERCISE AB, Vansbro, Sweden...
Page 4
Monark Exercise AB Monark has 100 years’ experience of bicycle production. The Monark tradition has yielded know-how, experience, and a real feel for the product and quality. Since the early 1900s, Monark’s cycles have been living proof of precision, reliability, strength and service. Those are the reasons why we are now the world leader in cycle ergometers and the market leader in Scandinavia in transport cycles.
640 mm (25”) at support tubes in Watts. Length Note that 927 X is an exercise model that can not be 1240 mm (48.8") calibrated. It is not for testing when the display just shows an estimate value.
If you want to make a setting in Miles unscrew the meter from the panel. On the back side is a switch with two settings – KM and MILES. Select the MILES mode and fasten the meter in the panel again. Fig: Display 1) Workload adjustment Monark 927 X...
You may turn UP and DOWN Fig: 10 Fig: 9 button to select level from 1 to 16 and press ENTER to confirm. See Fig: 10. Work load level can be adjusted during training. Monark 927 X...
Page 8
Press ENTER for 2 seconds. See Fig: 12. When meter displays abnormal segments, please turn it off and then turn it on again. Monark 927 X...
Page 9
Screen will display year / month / day in sleep mode. CLOCK: Screen will display time in sleep mode. MAINTENANCE Do not expose the meter to direct sunlight or extremely high temperature. Do not use any dissolvents when cleaning. Use only dry cloth. Monark 927 X...
Lock the adjustment screw and put the cover back. The bike is ready to use. Note that 927 X is an exercise bike that can not be calibrated. It is not for testing when the display just Fig: Workload spring, shows an estimate value.
The wire on the motor unit may have come out of position. Install the wrong direction, or otherwise behaving brake wire as shown in Fig: Brake wire assembly. strangely Fig: Brake wire assembly 1) Brake wire 2) Flywheel Monark 927 X...
EC Directive 1999/44/EC. In short, tightened. If not the threading in the pedal arms will the directive states for that your Monark Dealer will be damaged. Also check that pedal arms are firmly be liable for any defects, which existed at the time of tightened on the crank axle, tighten if necessary.
The flywheel bearing is long-term greased and requires Brake belt contact surface no supplementary lubrication. If a problem arises, please contact your Monark dealer. Deposits of dirt on the brake belt and on the contact surface may cause the unit to operate unevenly and will also wear down the brake belt.
4) Lock spring the centerline of the frame. Otherwise the chain and 5) Movement direction sprockets makes a lot of noise and wears out rapidly. 6) Chain lock Then assemble the removed parts as above but in reverse order. Monark 927 X...
The sprocket should be lubricated with a few drops of oil once a year. Tilt the cycle to make it easier for the oil to reach the bearing. See Fig: Lubrication. Fig: Lubrication Fig: Hub assembly Monark 927 X...
Need help?
Do you have a question about the 927 X and is the answer not in the manual?
Questions and answers