Download  Print this page

Display Of Faults And Information; Error - Ecomax G404 Installation And Operation Manual

Glass and dishwashers.
Hide thumbs

Advertisement

Installation and Operation Manual
9

Display of faults and information

Error code
Reason
01
Boiler sensor temperature exceeds setpoint.
02
Boiler sensor temperature below setpoint.
03
Hot water tank thermostop in wash programme. Contact your HOBART Service Partner.
05
Tank sensor temperature exceeds setpoint.
06
Tank sensor temperature below setpoint.
07
Total value of pressure sensor for boiler ex-
ceeded.
08
Total value of pressure sensor for boiler below
setpoint.
09
Total value of pressure sensor for tank exceed-
ed.
10
Total value of pressure sensor tank below
setpoint.
12
Water level regulation in wash tank failed.
13
Filling programme monitor pressure sensor
tank.
14
Wash tank draining in pump out programme for
pressure sensor tank.
17
Filling monitoring by impeller sensor.
18
Filling monitoring by measuring the water level
in the boiler.
21
Filling programme aborted.
28
Fill level of wash tank too low at programme
start.
29
Capacity of external water treatment unit ex-
hausted.
HOBART
9.1

Error

► "Er" appears in the top display.
► The error code is shown in the bottom display (see table).
IO-0000000235-001-EN / 13. Apr. 2017
Display of faults and information
Remedy
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Contact your HOBART Service Partner.
Pump out machine.
Clean the drain hose if necessary and pump-
out the machine again.
Check water supply.
Check water supply.
Close door.
Top up water and then run the wash pro-
gramme.
Replace part or full desalination cartridge.
ECOMAX
EN
33

Advertisement

Table of Contents

   Also See for Ecomax G404

   Related Manuals for Ecomax G404

This manual is also suitable for:

G504F504

Comments to this Manuals

Symbols: 0
Latest comments: