Download  Print this page

Advertisement

1 Basic Operation
The cableless measurement device is now added to the monitor.
If the corresponding internal measurement in the patient monitor is active, you will be asked to
confirm that it should be deactivated in favor of the cableless measurement device by selecting
If a cableless measurement of the same type is already assigned to the monitor, you will be asked to
confirm that it should be removed by selecting
Adding Manually
1
Prepare the SpO
pressing the hardkey.
2
Select the device key that appears in place of the Measurement Selection key, for example
This displays the
Measurements and telemetry devices:
Select the cableless measurement device to be added.
3
Select
4
If the corresponding internal measurement in the patient monitor is active, you will be asked to
confirm that it should be deactivated in favor of the cableless measurement device by selecting
Replace
If a cableless measurement of the same type is already assigned to the monitor, you will be asked to
confirm that it should be removed by selecting
For the SpO
Cableless Measurements Instructions for Use for details.
Removing a Cableless Measurement Device
To remove a cableless measurement device from a monitor and end the assignment:
Select the Measurement Selection key.
1
2
Select the cableless measurement device to be removed.
Select the
3
You can also remove cableless measurement devices in the same way as any other devices using the
Equipment
36
or NBP Pod for adding by holding the ◄ key pressed, or the Respiration Pod by
2
.
window, that shows any available IntelliVue Cableless
Add Cableless
. The device confirms the successful addition with a tone.
Add
.
and NBP Pods, adding can also be done directly on the device. See the IntelliVue
2
Remove
pop-up key.
window, see "Using the Equipment Window" on page 96.
Replace
.
Replace
.
Replace
.

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: