Download  Print this page

Safety And Performance Tests - Philips MP2 Instructions For Use Manual

Intellivue patient monitor.
Hide thumbs

Advertisement

24 Specifications
Gas or Vapor
Desflurane
Ethanol
Isopropanol
Acetone
Methane

Safety and Performance Tests

You must observe any national regulations on the qualification of the testing personnel and suitable
measuring and testing facilities. See the maintenance section for a list of required tests. Safety and
performance tests, and what to do if the instrument does not meet these specifications, are described
in the Service Guide.
Electromagnetic Compatibility (EMC) Specifications
Take special precautions regarding electromagnetic compatibility (EMC) when using medical electrical
equipment. You must operate your monitoring equipment according to the EMC information
provided in this book. Portable and mobile radiofrequency (RF) communications equipment can affect
medical electrical equipment.
Accessories Compliant with EMC Standards
All accessories listed in the accessories section comply, in combination with the monitor, with the
requirements of IEC 60601-1-2:2001 + A1:2004.
WARNING
Using accessories other than those specified may result in increased electromagnetic emission or
decreased electromagnetic immunity of the monitoring equipment.
Electromagnetic Emissions
The monitor is suitable for use in the electromagnetic environment specified in the table below. You
must ensure that it is used in such an environment.
Emissions test
Radiofrequency (RF) emissions
RF emissions CISPR 11
312
Gas Level
(% volume fraction)
15%
0.1%
0.1%
0.1%
1.0%
Compliance
Avoiding Electromagnetic Interference
Group 1
The monitor uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment
Class A
The monitor is suitable for use in all establishments other than those directly
connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
M8102A/M3014A
Additional deviation due to gas interference,
measured at 0 - 40 mmHg CO2
+5 mmHg
±1 mmHg
±1 mmHg
±1 mmHg
±1 mmHg
M3015A
±5%
±5%
±5%
±5%
±5%

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: