Download  Print this page

Advertisement

Touch the measurement numeric on the screen to enter the setup menu.
Key to measurement setup menu:
Item
1
2
3
4
5
Main Setup Menu
There is usually more than one way to enter a setup menu for a measurement, to change a setting or to
execute a task. Some routes are more direct than others. You can use whichever method you find most
convenient. Which routes are available to you, however, can vary depending on your monitor's
configuration.
For this reason, this book generally describes entry to a measurement's setup menu via the
menu, as this route is always available and is not subject to configuration dependencies. You can get to
all setup windows from the
SmartKeys key, then selecting the
Description
Comment
INOP and alarm
These are always displayed at the top of the screen.
message field
Wave/numerics
The main measurement numeric and wave (if applicable) are shown
window
in this window so that you do not lose sight of the current
measurement while making changes in the menu.
Status/prompt
Status/prompt messages related to the measurement menu are
message
displayed below the wave/numerics. General status/prompt
messages on the main screen are covered by the measurement setup
menu.
Next page arrows
The menu may have more than one page, as shown here. Move to
another page by touching these arrows.
Measurement menu
Each button has two lines of text. To perform an operation on a
keys
measurement, press one of the keys. Some keys lead directly to a
task. For example, pressing the
pressure starts a measurement. Other keys open a pop-up window,
which can have more than one page, from which you make a
selection. Again, using noninvasive blood pressure as an example,
pressing the
pop-up window from which you pick a time, scrolling if necessary.
Main Setup
Main Setup
Start/ Stop
Repeat Time
key for setting the repetition time opens a
menu. You enter the
Main Setup
SmartKey.
1 Basic Operation
key for noninvasive blood
Main Setup
menu by pressing the
25

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: