Download  Print this page

Advertisement

To assign a telemetry device to a monitor:
Press the Check button on the telemetry device.
1
The measurement selection key on the monitor will change to show the "add cableless" symbol
Select the symbol.
2
In the
window, select the correct equipment label for the telemetry device.
3
Add Cableless
Check that the assignment is successful and that transmission has begun:
4
A
Tele Device assigned
A tone sounds at the telemetry device and the Leads Off indicators light
The ECG wave appears on the monitor
To confirm that the correct telemetry device has been assigned, open the ECG Setup menu. The title
of the menu contains the equipment label of the telemetry device; check that this is the correct label.
If a telemetry device is already assigned to a monitor, you cannot assign a further telemetry device to
that monitor.
If the telemetry device goes out-of-range or loses the short range radio connection, it will switch over
to standard telemetry transmission to the Information Center. In this case, the telemetry data is
displayed in the Own Patient Overview Window as described above.
When a telemetry device with a short range radio adapter is assigned to the patient, the short range
radio connection to the monitor is made automatically.
If a telemetry device disappears from the list in the
telemetry device again. If the monitor is not configured to be used with a telemetry device, the add
cableless symbol will appear crossed out
If the telemetry device is removed (unassigned), the short range radio connection will be ended.
WARNING
Short range radio connections are subject to interruption due to interference from other radio sources
in the vicinity, including microwaves, bluetooth devices and DECT phones. Outside the operating
frequency band and 5% above and below, i.e. the exclusion band according IEC 60601-1-2, section
36.202.3a)4), the short range radio connection is immune up to 3V/m in the frequency range from
80 MHz to 2.0 GHz and up to 1V/m in the frequency range from 2.0 to 2.3 GHz. Depending on the
strength and duration of the interference, the interruption may occur for an extended period. A loss of
connection, due to moving out-of-range, interference, or for other reasons, is indicated with a
Disconnected
INOP.
Correct channel configuration is important, refer to the Configuration Guide for details.
If a
Tele Disconnected
INOP occurs when the telemetry device goes out-of-range, the INOP will
disappear (without being silenced) as soon as the ECG signal from the telemetry device is available at
the Information Center via standard telemetry transmission.
15 Using a Telemetry Device and a Monitor
message appears on the monitor
Add Cableless
.
menu, press the Check button on the
Tele
217

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: