Menus - GE D60 Instruction Manual

4 HUMAN INTERFACES
ENTER COMMAND
PASSWORD
Press USER 1
To Select Breaker
BKR1-(Name) SELECTED
USER 2=CLS/USER 3=OP
(1)
USER 2 OFF/ON
To Close BKR1-(Name)
(2)
USER 3 OFF/ON
To Open BKR1-(Name)
(3)
BKR2-(Name) SELECTED
USER 2=CLS/USER 3=OP
e) CONTROL OF ONE BREAKER
For this application the relay is connected and programmed for breaker No. 1 only. Operation for this application is identical
to that described for two breakers.
a) NAVIGATION
Press the key to select the desired header display page (top-level menu). The header title appears momentarily fol-
lowed by a header display page menu item. Each press of the
illustrated below.
!
ACTUAL VALUES
"
## ACTUAL VALUES
## STATUS
!
USER DISPLAYS
(when in use)
"
User Display 1
GE Multilin
This message appears when the USER 1, USER 2, or USER 3 key is pressed and a
is required; i.e. if
COMMAND PASSWORD
mands have been issued within the last 30 minutes.
This message appears if the correct password is entered or if none is required. This mes-
sage will be maintained for 30 seconds or until the USER 1 key is pressed again.
This message is displayed after the USER 1 key is pressed for the second time. Three
possible actions can be performed from this state within 30 seconds as per items (1), (2)
and (3) below:
If the USER 2 key is pressed, this message appears for 20 seconds. If the USER 2 key is
pressed again within that time, a signal is created that can be programmed to operate an
output relay to close breaker No. 1.
If the USER 3 key is pressed, this message appears for 20 seconds. If the USER 3 key is
pressed again within that time, a signal is created that can be programmed to operate an
output relay to open breaker No. 1.
If the USER 1 key is pressed at this step, this message appears showing that a different
breaker is selected. Three possible actions can be performed from this state as per (1),
(2) and (3). Repeatedly pressing the USER 1 key alternates between available breakers.
Pressing keys other than USER 1, 2 or 3 at any time aborts the breaker control function.
!
SETTINGS
"
## SETTINGS
## PRODUCT SETUP
D60 Line Distance Relay
4.2 FACEPLATE INTERFACE
COMMAND PASSWORD
key advances through the main heading pages as
!
COMMANDS
"
## COMMANDS
## VIRTUAL INPUTS
is enabled and no com-
4

4.2.6 MENUS

TARGETS
"
No Active
Targets
4-9