Before Using The Tv/Vcr 5 - Philips CCB 134AT Owner's Manual

Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the bottom of
the remote control by pressing in the tab, then pulling up
the lid.
2
Place three AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.
Erasure Prevention
Video cassette tapes have record tabs to ensure that recordings
are not accidentally erased.
1
To prevent accidental erasure, break off the tab with a
screwdriver.
2
To record again, cover the hole with cellophane tape.
Using the Remote Control
Point the remote control at the TV/VCR's remote sensor, then
press the COMBI button when using the remote control to
operate the TV/VCR. Point the remote control at the Cable
Box/DBS, then press the CABLE/DBS button when using the
remote control to operate the Cable Box/DBS.
Do not put objects between the remote control and the TV/VCR.
TV/VCR Maintenance
In this TV/VCR, use only tapes with the
other tapes may result in poor picture quality and excessive
deposits on the video heads, which may not be covered by the
warranty if damage occurs.
Make sure any light adhesive stick-on notes are removed from the
video cassette tape before putting the tape in the TV/VCR.
Removable labels like these can jam the TV/VCR.
Periodic maintenance is required to maintain your TV/VCR's excel-
lent performance. This TV/VCR has an automatic head cleaning
system. However, the video heads will eventually require cleaning
or replacement. Only an authorized service center should perform
this service.

Before Using the TV/VCR 5

mark. The use of
Helpful Hints
• The remote control and its batteries
are supplied.
• Do not mix alkaline and man-
ganese batteries.
• Do not mix old and new batteries.
1
2
3
1
2