Install The Batteries; Power On The Clamp Meter; Using The Wire Separator And Hook - Keysight U1191A Quick Start Manual

U1190A Series Handheld Clamp Meter

Install the Batteries

Install the Batteries
Your clamp meter is powered by two
1.5 V AAA alkaline batteries (included
with the shipment).
1 Turn the clamp meter OFF and remove
the test leads from the terminals.
2 Loosen the screw on the battery cover
with a suitable Phillips screwdriver.
3 Remove the battery cover and observe
the polarity markings.
4 Insert the batteries and replace the
battery cover and screw.

Power ON the Clamp Meter

Using the Wire Separator and Hook

1 Open the clamp jaw
slightly to reveal the
wire separator tip.
2
To power ON your clamp meter,
turn the rotary switch from the
OFF position to any other posi-
tion.
Mesh of
wires or
cables
2 Separate the
desired wire or
cable by hooking it
in the clamp jaw.
U1190A Series Quick Start Guide
3 Secure the
wire or cable
and read the
measurement.