Siemens SIMOVERT MASTERDRIVES Operating Instructions Manual page 29

03.99
Siemens AG 6SE7087-6NX84-0GB0
SIMOVERT MASTERDRIVES
Monitoring Description
code
0000h { Monitor value is 0000 }
0001h Output frequency
0002h Output current
0003h Output voltage
0004h { Monitor value is 0000 }
0005h Frequency set value
0006h Operating speed
0007h Motor torque
000Fh Input terminal status
0010h Output terminal status
8001h Optional actual value 1
8002h Optional actual value 2
8003h Optional actual value 3
8004h Optional actual value 4
8005h Optional actual value 5
8006h Optional actual value 6
8007h Optional actual value 7
8008h Optional actual value 8
Table 4-3 Monitor code
The monitoring values can be read in Mitsubishi inverter data format or
MASTERDRIVES data format (signed or unsigned); refer to chapter
4.9, "Data formats and data conversion". You select your data format
by the parameters P715 till P718.
The monitor values with monitor code ≤ 0007 can be handled in both
data formats (depending on according scaling). The monitor values with
monitor code ≥ 8001 are not converted. They have the original
MASTERDRIVES data format.
The monitor code 000Fh and 0010h shows some of the control bits
(remote IO bits):
Monitor Code 000Fh: input terminal status
Bit 15 Bit 9
0000.000
Bit 7 JOG is set if JOG1 (RYn5) or JOG2 (RYn7) is activated.
Monitor Code 0010h: output terminal status
Bit 15
0000.0000.000
Operating Instructions
According
scaling
parameter
-
P717
P715
P716
-
P717
P718
-
-
-
-
-
-
-
-
-
-
-
Bit 8 Bit 7 Bit 6 Bit 5
MRS JOG RH RM
Bit 5
Communication via CC-Link
Precision of Mitsubishi
data format (1 digit)
0.01 Hz
0.01 A
0.1 V
0.01 Hz
1 rotation/min
0.1 %
-
-
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
MASTERDRIVES format
Bit 4 Bit 3 Bit 2 Bit 1
RL RT 0 STR
Bit 4 Bit 3 Bit 2 Bit 1
FU OL IPF SU
Bit 0
STF
Bit 0
RUN
4-9