System Issues; Troubleshooting; Error Codes; Warranty - Panasonic LJ-SK56A User Manual

Battery System User Manual for Panasonic LJ-SK84A

8.0 SYSTEM ISSUES

8.1 Troubleshooting

Please consult the table below if you have concerns that the battery system is not operating normally.
Problem
The battery stops discharging
The battery stops charging
The Stand-alone power outlet does not work
The battery does not work
The display shows an error

8.2 Error codes

Please consult the list below if the battery displays an error code.
E010 High grid voltage
E020 Low grid voltage
E030 AC over frequency
E040 AC under frequency
E060 Abnormal grid
E070 Instantaneous over voltage
E080 Instantaneous under voltage
P620, P690 Over discharged
P660, P700 High temperature
H010 toH990 The battery switched off to
prevent serious damage and
needs to be serviced.
F010 to F990 Battery failure!
If you get any of the above error codes on a regular basis it is likely that there is an external issue.
In this case, please contact solarcity so we can help to rectify any issues.

9.0 WARRANTY

For solarZero+ customers we manage the battery system and replace it when it reaches the end of its useful life as
part of our energy service.
If you have purchased the battery outright please refer to the Panasonic Warranty on page 30 of the separate
Panasonic User Manual which can be downloaded here:
http://www.solarcity.co.nz/assets/Uploads/productmanuals/LJ-SK56A-usermanual-20161028.pdf
Either the battery is fully discharged or has reached
the lower discharge limit set.
At very low or high temperatures the battery may
stop discharging early to protect the battery
The battery is fully charged.
At very low temperatures the battery may stop
charging early to protect the battery.
The Stand-alone power outlet can only be used
during a power cut. Stand-alone operation needs to
be activated manually.
The Stand-alone outlet RCD might have tripped.
Please contact solarcity.
If timers have been set under menu item no -3, the
battery will not work in SELF mode. Make sure all
timers are set to 00:00.
Consult section 8.2 or contact solarcity
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Normal operation will resume once conditions improve
Contact solarcity immediately
Contact solarcity as battery most likely needs
replacement
12
Grid Tied PV System – User Manual
Version 1.0 © solarcity 2016 UM-1059-PV-1.0
Solution