Step 2. Startup - Cisco 3G MicroCell User Manual

Step 2. Startup

Note: Make sure all Ethernet cabling is complete before performing this task.
1. Turn off power to your PC, router (if you have one), modem or gateway.
Note: If equipped with a backup battery, it may be necessary to press "reset" on your modem or gateway. See the user
documentation for your device.
Make sure all of the devices are turned off before you go to the next step.
2. Wait a minute, then turn on the modem or
gateway first, the router second (if you have
one), and the PC last. Wait a few moments
before turning on each device.
3. Find the AC adapter that came with your
MicroCell and connect it as shown.
4. Verify the status of your devices.
• Make sure that the Power status
indicator on the front panel is steady
green and that the Ethernet and PC
status indicators are flashing or steady
green.
• Make sure that the status indicators on
your router (if you have one), modem or
gateway are operating as they normally
do (this may take a few minutes).
5. Open a browser on your PC and connect
to the Internet.
Go to the AT&T 3G MicroCell™ home page:
If you can connect to the MicroCell home page, then you have performed the Ethernet Cabling and Startup tasks correctly.
Congratulations! Go to Step 3. Account Activation.
What if you can't connect to the AT&T 3G MicroCell™ home page?
If you are having trouble connecting to the Internet, confirm Step 1. Ethernet Cabling and Step 2. Startup. If that doesn't
help, refer to the Troubleshooting section on page 15.
4030453_RevA_6.75x8.25_Mar6.indd 11 4030453_RevA_6.75x8.25_Mar6.indd 11
AT&T 3G
MicroCell ™
Antenna
Computer
Ethernet
Reset
Power
att.com/3GMicroCell
AC Power Power
Adapter Outlet
3
T14078
11
3/6/2009 5:43:33 PM 3/6/2009 5:43:33 PM