T E C H N I C A L I N F O R M A T I O N
Each resource can be set to either Available or Not available.
If shown as available, it is assumed by the system not to be in use by
any ISA card or device and therefore will be made available for the
PCI auto-configure process. Although many ISA cards are very
simple to configure, the resources they use, if any, must be
registered in the BIOS.
ISA Graphics/Video device
Choice of present or not present. Default is 'not present' unless the
system has an ISA video board fitted.
The individual parts of the system can be selected to be shut down in
the 'Low power mode' by enabling or disabling them in this menu.
Some of the settings have been pre-set in the factory to comply with
the Energy Star Programme.
Standby mode for Hard disk
Standby mode for monitor
Standby mode for CPU
The energy saving features built into this computer are designed to be used with
the monitor supplied with the system. If you wish to use another, or older
monitor it may not be compatible and permanent damage may be caused.
Check with your Apricot dealer.
Disable, Enable. (timing fixed at 20 mins.)
Disable, or range of times. (in minutes)
(* see warning below)
Disable, Slow CPU.