Download  Print this page

Advertisement

T H E S Y S T E M D R I V E S
It should not be necessary to actually remove any internal screws,
merely loosen them sufficiently to remove an assembly.
Remove the floppy drive assembly, slide it towards the rear of the
system and lift it out. It may be necessary to temporarily disconnect
drive cables. Take careful note of how they are fitted.
Locate and loosen the four screws that hold the CD-ROM drive
assembly into the system, slide it back and lift it out.
Again, you may have to temporarily disconnect any wires and cables
on any fitted drives. You now have access to the hard disk drive
assembly.
Loosen the screws holding it to the baseplate and lift carefully out.
Observe anti-static precautions and check the new IDE drive's
master/slave links as shown. For a master, or first drive, link across
DS. For a slave, or second drive, remove the link, but retain it by
placing it onto one of the two pins. Take great care, as this link is
very small. (Any existing installed drive should already be linked
2/6
1
3
2
4

Advertisement

Table of Contents

   Also See for Mitsubishi Electric Apricot LS

Comments to this Manuals

Symbols: 0
Latest comments: