Table of Contents
Advertisement
getting started
2.
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
•
Setting up the hardware
•
Supplied software
•
System requirements
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the
Quick Install Guide. Make sure you read the Quick Install Guide first and
follow the steps below:
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,500 m (4,921 ft). Refer to the
altitude setting to optimize your printing. (See "Altitude adjustment" on
page 49.)
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
•
Installing USB connected machine's driver
•
Sharing your machine locally
2. Unpack the machine and check all the enclosed items.
3. Remove tape holding the machine securely.
4. Install the toner cartridge.
5. Load paper. (See "Loading paper in the tray" on page 55.)
6. Make sure that all cables are connected to the machine.
7. Turn the machine on.
SUPPLIED SOFTWARE
After you have set up your machine and connected it to your computer., you
must install the printer and scanner software using the supplied CD . The
software CD provides you with the following software.
Getting started_ 32
Advertisement
Table of Contents
