4.2. System operation - amplifiers
Fly 6 and Fly Sub 12
built-in power amplifier:
1
2
LIMIT
3
TEMP
SIGNAL
READY
4
5
PRESET
SELECT
7
10
11
1. VOLUME KNOB. Used for adjusting the
volume of the system. Remember to turn
the volume dowm before connecting/
disconnecting INPUT or LINK connectors.
2. LIMIT LED. Is lit when limiter is
operational, indicating excessive signal
through the system.
3. TEMP LED. Is lit when tempreture
protection is in place, indicating
overheating.
4. SINGAL LED. Is lit when signal is present
on the INPUT connector.
11
PRESET1
PRESET2
6
PRESET3
PRESET4
8
9
12
5. READY LED. Is lit when system is fully
operational.
6. PRESET LEDS. Indicate the currently
selected system preset. For preset
description, refer to the "4.4 System
Operation - Configurations" section of this
manual, page 13.
7. LINK CONNECTOR. Used for linking
additional compactible system to same
signal source.
8. INPUT CONNECTOR. Used for
connecting the system to the signal
Fly Array User Manual rev 0.1
Fly Sub 15 and Fly Sub 18
built-in power amplifier:
2
LIMIT
3
TEMP
SIGNAL
READY
4
5
7
10
11
source (mixing console etc.)
9. PRESET SELECT BUTTON. Used for
switching currently selected system
preset.
10. HEAT SINK. Large heat sink for
effective heat dissipation.
11. PowerCon A CONNECTOR. Used for
connecting mains supply to the system.
12. PowerCon B CONNECTOR. Used for
feeding the mains supply to the additional
system.
1
PRESET1
PRESET2
PRESET3
PRESET4
PRESET
SELECT
12
6
8
9
Need help?
Do you have a question about the Fly 6 and is the answer not in the manual?
Questions and answers