Other Connections; Connecting A Tv - Yamaha DVX-1000 Owner's Manual

■ Connecting a TV

Notes
– You only need to make one video connection from the following options (A, B, C, or D), depending on the
capabilities of your TV.
– Do not connect the power cords until all cable connections are completed.
<A>
AUX IN
M DIGITAL IN
OR OPTICAL L
R
PCM/DTS
q DIGITAL AUDIO
COMPONENT VIDEO OUT jacks <A>
Use the component video cables (red/blue/green, not
supplied) to connect the DVD receiver's Y P
the corresponding component video input jacks (or the Y
Pb/Cb Pr/Cr/ YUV jacks) on your TV.
Progressive scan video quality is only available when
using Y P P in conjunction with a progressive scan TV.
B R
To activate the progressive scan function see "Progressive
function" on page 40.
VIDEO output jack <B>
Use a composite video cable (yellow -supplied) to connect
the DVD receiver's VIDEO output jack to the video input
jack (or A/V In/Video In/Composite/Baseband jack) on
your TV.
S VIDEO output jack <C>
S (separate)-video connections achieve a clearer picture
than composite video connections. Use an S-video cable
(not supplied) to connect the DVD receiver's
S VIDEO output jack to the S-video input jack (or Y/C or
S-VHS jack) on your TV.
14
En

Other connections

<B>
Y
LINE OUT
VIDEO
P
B
L
VIDEO OUT
(DVD ONLY)
P
R
R
S VIDEO
COMPONENT
P jacks to
B R
<C>
<D>
AV MONITOR OUT
(DVD ONLY)
AV MONITOR OUT terminal <D>
(Europe and Russia models only)
The SCART cable, or "Euro AV cable", supports AV
MONITOR OUT signal transmission, providing you with
the best possible picture and sound. If your TV has only
one terminal for video input, and you want to connect it
directly to the DVD receiver, you can use the AV
MONITOR OUT connector. Connect one end of the
SCART cable to the AV MONITOR OUT connector and
the other end to the SCART connector on your TV.
Notes
– TV channels, if you use AV MONITOR OUT
terminal to connect the TV. To use AV MONITOR
OUT terminal, make sure to set the DVD
receiver's component setting to "RGB" (see
page 22).
– When using AV MONITOR OUT terminal to
listen to the TV channels, set the DVD receiver's
component setting to "RGB" (see page 22).
– S-video signal is not output at AV MONITOR
OUT terminal.
TV