Dell 1600n User Manual page 166

Static Addressing
To enter the TCP/IP address from your printer's operator panel, take the following steps:
1
2
3
4
5
6
7
8
9
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically by the server, take the following steps:
1
2
3
4
5
14 4
Ne t wo r ki ng
Press <Menu> until you see "Network Setup" on the bottom line of the display.
Press the scroll button ( or ) until you see "Configuration" displays on the
bottom line. Press <Select>.
Press the scroll button ( or ) to display "TCP/IP" and press <Select>.
The first available menu item, "Manual", appears on the bottom line and press
<Select>.
The first available menu item, "IP Address" displays on the bottom line.
Press <Select> to access the IP Address menu.
An IP address consists of 4 bytes.
Enter a number between 0
and 255 for each byte.
Enter the numbers from the keypad and use the scroll button ( or ) to move
between octets and press <Select>.
Repeat Step 5 to complete the address from the 1st byte to the 4th byte.
To select other parameters, such as the Subnet Mask, Gateway or Primary DNS, press
<Return>, then use the scroll button ( or ). Press <Select>.
Repeat steps 5 through 8 to configure the other TCP/IP parameters.
Press <Menu> until you see "Network Setup" on the bottom line of the display.
Press the scroll button ( or ) until you see "Configuration" displays on the
bottom line. Press <Select>.
Press the scroll button ( or ) to display "TCP/IP" and press <Select>.
Press the scroll button ( or ) to display "DHCP" on the bottom line and press
<Select>.
To assign the address from the BOOTP server, press <Select> when "BOOTP" displays
on the bottom line.