Wiring Diagram - Makita DGA405 Technical Information

W
iring diagram
Fig. D-2
Fix Lead wires in these Lead wire holders one by one.
Pin A
Boss B
Route three thick lead wires (orange, white, blue)
of Controller between Pin A and Pin B.
Note: Insert the plate end of Non-insulated terminal into Switch terminal No. 3
as drawn in Figs. R and D-1 of page 10.
Fig. R
Housing
set L
Controller
Terminal
Rib H
Wiring of Controller to Stator complete
Pin B
Rib B
Rib D
Boss for fitting
Switch unit
Wiring after setting Switch and Switch unit
Switch
Housing set R side
Put Connectors (of Lead wires
for Switch unit and Controller)
in this space.
Switch
Connectors
Rib E
Rib F
Rib G
Line filter (if used)
Put Line filter between Rib G and Rib H.
Bend thick lead wires (orange, white, blue) of Controller
here so as not to pinched between mating portions of
Housing L and R.
Boss A Rib A
Route Polyolefin tube of Controller between;
• Rib A and Boss A
• Rib B and Boss for Switch unit fitting
• Rib B and Rib D
• Pin A and Boss B
Fig. F
Housing
set L
Housing set R side
Fix Lead wires from Switch unit
in these Lead wire holders.
Switch unit
Route lead wires (red, yellow, black) of Terminal
between Rib E and Rib F.
P 11/ 11
Switch
Stator