Circuit Breaker - Peavey PVX pSub Operating Manual

A Full-Range Thru output has a male XLR connector. These outputs allow linking of additional speaker systems,
or feed of the signal to other devices, etc. Included in the input panel is a bay for optional function modules,
such as a Wireless Receiver, Digital Audio Input or a 10-band EQ, etc.
APPLICATIONS
The Peavey PVX
full-range speaker systems for sound reinforcement, public address, side fill system, karaoke or musical
playback.
A typical signal source for the line-level inputs of the Peavey PVXp Sub would be a sound reinforcement mixing
console (mixer) or the output from a CD player, MP3 player or tape deck. The high-pass filtered signal from the
PVXp Sub would then be sent to a full-range powered speaker system, easing the burden of deep bass from this
speaker system.
REAR PANEL BOTTOM

CIRCUIT BREAKER (1)

The unit is AC power line protected from overloads and fault conditions with a 5 amp circuit breaker. This
breaker should not trip unless there is a fault in the amplifier circuitry or an abnormal operating condition,
which causes excessive mains current to flow. If the breaker trips, set the Power switch (3) to OFF, and after
waiting a brief period of time for the breaker to cool, reset the breaker.
If the circuit breaker trips, the center button will pop outward approximately 1/4", and can be reset by pushing
upward and inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it, the
system should be taken to a qualified Peavey Service Center for repair.
IEC POWER CORD CONNECTION (2)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that
you ensure the PVXp Sub has the proper AC line voltage supplied. You can find the proper voltage for your PVXp
Sub printed next to the IEC line (power) cord on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
™
p Sub has a variety of applications, such as extending the bass performance of smaller
1
3
2