Before Installation - Panasonic KX-TDE100 Installation Manual

3.1 Before Installation

3.1 Before Installation
3.1.1 Before Installation
Please read the following notes concerning installation and connection before installing the PBX and
terminal equipment.
Be sure to comply with all applicable laws, regulations, and guidelines.
Safety Installation Instructions
When installing telephone wiring, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
1.
Never install telephone wiring during a lightning storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected
at the network interface.
4.
Use caution when installing or modifying telephone lines.
5.
Anti-static precautions should be taken during installation.
Installation Precautions
This set is made for wall mounting (KX-TDE100/KX-TDE200) or floor standing (KX-TDE200 only), and
should be installed in a location where it is accessible for inspections and maintenance.
To prevent malfunction, noise, or discoloration, avoid installing the system in the following locations:
1.
In direct sunlight and hot, cold, or humid places. (Temperature range: 0
2.
Areas where sulfuric gases may be present, such as near thermal springs.
3.
Areas where shocks or vibrations are frequent or strong.
4.
High-dust areas, or places the system may come into contact with water or oil.
5.
Near devices that generate high frequencies, such as sewing machines or electric welders.
6.
On or near computers, telexes, or other office equipment, as well as microwave ovens or air
conditioners. (It is preferable not to install the system in the same room as the above equipment.)
7.
Within 1.8 m (6 ft) of radios and televisions. (Both the PBX and PTs should be at least 1.8 m (6 ft) away
from such devices).
8.
Locations where other objects will obstruct the area around the PBX. Be especially careful to leave at
least 20 cm (8 in) of space above and 10 cm (4 in) to the sides of the PBX for ventilation.
9.
Do not block the openings of the PBX.
10.
Do not stack up the optional service cards.
Wiring Precautions
Be sure to follow these instructions when wiring the unit:
1.
Do not run unshielded telephone cables near AC power cables, computer cables, AC power sources,
etc. When running cables near other noise-generating devices or cables, use shielded telephone
cables or shield the telephone cables with metal tubing.
2.
If cables are run on the floor, use protectors to prevent the cables from being stepped on. Avoid running
cables under carpets.
48 Installation Manual
to 40 )
˚C ˚C