External Modem Connection
To RS-232C port (25-pin)
To CO line/PBX extension port
assigned as the CO line destination
External Modem (25-pin)
After connecting the PBX and the external modem, set the power switch of the external modem to "ON",
then the external modem will be initialized with the default values.
The following AT command settings may be required for the modem:
The Data Terminal Ready (DTR) signal should be ignored.
The Data Terminal Equipment (DTE)/Modem flow control should be turned off.
Data compression should be disabled.
Error Correction is not necessary.
Use an RS-232C straight cable for connection between the PBX and external modem.
An AT command (for initialization, enabling automatic answer, etc.) can only be programmed by
KX-TDE Maintenance Console. "AT&F" is stored as the default value.
For more information about the AT command, refer to the external modem's instructions.