3.14 Starting the PBX
Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will
For safety reasons, do not stretch, bend, or pinch the AC power cord.
To AC Outlet
While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.
Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will
be initialized to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW card will not be initialized.
Use only the AC power cord included with the PSU.
Confirming the CO Line Connection
After initialization, program the PBX and connect CO lines to the PBX.
To confirm that the CO lines are successfully connected, dial [ ]   + CO line number (3 digits) on a PT,
or press the PT's S-CO button. You will hear a dial tone if the CO line is available and connected.
PBX status indication
OFF: Power Off (includes normal reset)
ON: Power On and running (on-line)
Flashing (60 times per minute): Starting up
Flashing (120 times per minute): Starting up or resetting with:
ON: Alarm (CPU stop, alarm for each optional service card)
Flashing: Alarm (IPCMPR file error in restarting)
the System Initialize Switch in "SYSTEM INITIALIZE"
the SD Memory Card not inserted