Elation PLATINUM 1200 WASH User Manual page 16

MAIN MENU SUB MENU
Reset All
Reset Function
Reset Pan&Tilt
Reset Zoom
Test Channel
Effect Adjust
Manual Control
Calibration
User Mode
User Mode Set
Edit User Mode
Select Program
Edit Program
Edit Program
Edit Scenes
Rec. Controller
PERSONALITY - Status Settings - Address Via DMX
When ON, define the desired fixture DMX address via an external controller.
NOTE: This process assumes the fixture DMX address is set to 001. If fixture DMX address is not at 001,
you must adjust the channel numbers accordingly in order for this feature to work.
For example: if your fixture address is 010, then Channel 1 becomes Channel 10, Channel 2
becomes Channel 11, and Channel 3 becomes Channel 12.
1. Connect the fixture to the external controller and power ON.
2. Set the DMX value of Channel 1 on the controller to (7).
3. Set the DMX value of Channel 2 on the controller to (7) or (8).
When set to (7), the DMX address can be set between (1) and (255).
When set to (8), the DMX address can be set between (256) and (511).
4. Using Channel 3 on the controller set the desired DMX address of the fixture.
Example 1: If the desired DMX address is 57, set Channel 1 to a value of (7), set
Channel 2 to a value of (7), and then set Channel 3 to a value of (57).
Example 2: If the desired DMX address is 420, set Channel 1 to a value of (7), set
Channel 2 to a value of (8), and then set Channel 3 to a value of (164).
(256+164=420)
5. After setting Channel 3 to the desired DMX address value, wait for approximately
20 seconds (some fixtures may require a longer time) for the new address to be
assigned to the fixture.
www.elationlighting.com
ELATION© PLATINUM 1200 WASH™ S Y S T E M M E N U
Features are subject to change without any prior written notice.
Supports Software Versions: ≥ 2.1.0
OPTIONS / VALUES
PAN ......
PAN =XXX, ......
Calibration Password
Standard Mode
Basic Mode
Extended Mode
User Mode A
User Mode B
User Mode C
Edit User Mode A
Edit User Mode B
Edit User Mode C
Auto Pro Part1 = Program 1~10 (Program 1)
Auto Pro Part2 = Program 1~10 (Program 2)
Auto Pro Part3 = Program 1~10 (Program 3)
Program 1
:
Program 10
Scene 001
~
Scene 250
XX~XX
(Default Settings in BOLD)
Max Channel = XX
PAN = CH01
Program Test
Step 01=SCxxx
Step 64=SCxxx
Pan,Tilt,......
--Fade Time--
--Scene Time--
Input By Outside
16
DESCRIPTION
Reset All Motors
Reset Pan/Tilt
Reset Zoom
Test function
Fine Adjustments
Password 050
DMX Channel Modes
User Defined Channel Assignment
Edits User Defined
Channel Assignments
Select Programs To Be Run
Testing Program
Program In Loop
Save and Exit
Save and Automatically Return
Manual Scenes Edit
Stores Scenes via Ext DMX Console
Automatic Scenes Recorder