Table of Contents
Advertisement
Operating Instructions
Starting your air conditioner
Electrical
Shock Hazard
l
Plug unit only into grounded
electrical
outlet.
l
Do not use an extension
cord.
l
Do not operate unit with front removed.
Failure to follow the above precautions
could result in electrical
shock or personal
injury.
1. Set Exhaust
Control
to CLOSED (OFF) for
maximum cooling.
2. Set System Control
to the desired setting.
LO COOL (LO) . . . . . . . . . . . . . . . . . for sleeping comfort
MED COOL (MED)'
. . . . . . . . . . . . for normal cooling
HI COOL (HI) ._................ for maximum cooling
FAN ONLY*
. ..for circulating room air when no
cooling is desired
'On some models
3. Turn the Thermostat
Control
to number 6
(mid-setting).
You can adjust the air condi-
tioner's cooling performance
by resetting the
Thermostat
Control to a higher number for
maximum cooling. Lower the number setting
for less cooling. You will need to experiment
to
find the setting which suits you best.
NOTE: If you turn your air conditioner off or if the
compressor turns off when lowering the Thermo-
stat Control, wait at least 3 minutes before turning
it back on or you may blow a fuse or trip a circuit
breaker.
The ENERGY SAVER settings
(on some models)
The ENERGY SAVER settings are the three
settings to the bottom of the System Control (HI,
MED and LO). These settings save energy. The
fan will cycle on and off as the Thermostat
Control turns the compressor on and off. This
saves the cost of electrical energy that would be
used to run the fan continuously.
It is normal for the fan to turn on and off in the
ENERGY SAVER settings. The amount of time
the unit will be off depends on the room tempera-
ture and Thermostat Control setting.
20
Advertisement
Table of Contents
