Installing The Switch; Installing The Switch In A 19-Inch Rack - HP FlexNetwork 5120 SI Series Installation Manual

Installing the switch

CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open
the chassis, contact your local Hewlett Packard Enterprise agent for permission. Otherwise, Hewlett
Packard Enterprise shall not be liable for any consequence caused thereby.
Figure 1 Hardware installation flow
Install the switch to
the specified position
Connect the ground wire
Connect the power cord
Verify the Installation
Power on the switch
Operates normally？
Install the transceivers and

Installing the switch in a 19-inch rack

Figure 2 shows the general procedure for installing the switch in a 19-inch rack.
Figure 2 Install the switch in a 19-inch rack
Determine the mounting position
for the mounting brackets
Start
No
Yes
cables
End
Troubleshoot
Power off the
switch
Attach the mounting
brackets to the switch
6
Mount the switch in a rack