How To Execute Program Software (Plsc1209); Keyboard Operation (Plsc1209); Menus - JVC TK-C675BU Service Manual

2.5 HOW TO EXECUTE PROGRAM SOFTWARE (PLSC1209)

1) Install the MS-DOS "MOUSE. COM". (This program can also
be used without Mouse.)
2) At the MS-DOS command line, type as follows.
A>TK-C675 {/N or /P} [/BW] [/COM2] <Enter>
/N or /P Set type of TV system. The program cannot
start without specified.
N : NTSC
P : PAL
/BW Set if the monitor is Black & white.
/COM2 Set if a serial mouse is connected to the
COM1 serial port to allow camera data com-
municate via COM2. If not specified, COM1
becomes the main communication port auto-
matically.
3) At the "Welcome" message, click <OK> or press [ENTER]
key.
Follow the message appearing on the display to prepare and
execute each setting.
4) When the main window is displayed, data communication
begins. However, if due to faulty connection or other abnor-
mality, the program stops. Observe the check indication at
the lower right of the screen. If indication is "NG", check
the cable connections and camera power. When indication
is "OK", the program operation starts. If communication is
abnormal, press the [Break] key to terminate the program.
5) When the program starts, check the TV system indication of
the main window. If this is incorrect, restart the program
and correct the TV system entry.
To terminate the program, click the EEPROM menu, then
click Quit (or press [Crtl] + [F4] keys).
NOTE
For Remote Control Software (PLSC1210), See instruc-
tion manual attached to the software. Not described on
this Service Manual.

2.7 MENUS

1) EEPROM Menu
Menu command
Read
Backup
Restore
Edit
Compare
Difference
Esc compare
Help
Quit
2-3
(U Ver.)
(E Ver.)
Readout EEPROM data (256 bytes) from camera.
Backup EEPROM readout data to disk.
Write disk backup data or EEPROM initial data of this disk into camera EEPROM.
After EEPROM data readout, edit the data of a selected address (if using a mouse, double click
the desired address of the data table). Use care since editing rewrites the camera EEPROM
data.
Compare EEPROM readout data with data in disk. Different data's color are change on the
screen.
After comparing the data, data difference of a selected address is displayed.
(Double click the desired address data of the data table.)
End comparison
Display "README. DOC" file.
Terminate program.

2.6 KEYBOARD OPERATION (PLSC1209)

Although a mouse is recommended for using this program, it
can also be operated from the keyboard in cases when a mouse
is not available.
The commonly use keys are as follows.
Key
[Alt]
[Enter]
[Esc]
[Up] or [Shift] + [Up]
[Down] or [Shift] + [Down]
[Left] or [Shift] + [Left]
[Right] or [Shift] + [Right]
[Tab] or [Shift] + [Tab]
[Insert]
[Delete]
[Back space]
Short key operations are indicated on the screen.
Function
Function
Menu selection
Confirm
Cancel
Cursor shift
Cursor shift
Cursor shift
Cursor shift
Item select
Insert or Overwrite text
Delete text
Cursor backspace during
text input