If this happens:
One or more Media Type
options are dimmed.
iR C2100/2100S doesn't
respond to a Print
You cannot print with
QuarkXPress 3.32 using
the PSPrinter 8.7 driver on
a Mac OS computer.
Select a Paper Source that supports the Media Type you are using.
For information on requirements and constraints pertaining to special
papers and transparencies, see Appendix A
Has someone disconnected the copier/printer by selecting Suspend Printing
from the Functions menu?
If the administrator or operator has selected
iR C2100/2100S Control Panel or Command WorkStation to interrupt
printing, your print job will not resume until someone selects
from the Functions menu on the Control Panel or clicks the
function key on the Command WorkStation.
Did you select the iR C2100/2100S as the current printer?
Before printing, you must select the iR C2100/2100S as the current printer
from your Windows computer, Mac OS computer, or UNIX workstation.
Make sure the copier/printer is switched on.
Someone may have turned the copier/printer off, or the Automatic Power-
Off or Power Saver mode function may have engaged. Even with the copier/
printer off, the iR C2100/2100S appears in the Chooser as long as the
iR C2100/2100S itself is turned on.
If you are printing over an IPX (Novell) network, verify through the
PCONSOLE utility that the job was sent to the Novell queue and that the
queue is being used by the iR C2100/2100S.
Make sure the job does not contain a PostScript error.
Check with the operator, or use Command WorkStation, Fiery WebSpooler,
or Fiery Spooler to check the job's status. A job containing a PostScript error
appears in red.
To obtain information on the PostScript error, make sure the Print to PS
Error option is set to
Guide for more information.
Remove the ﬁle called Balloon Help from your QuarkXPress application folder
and relaunch QuarkXPress.
in iR C2100/2100S Setup. See the Conﬁguration