Call Forwarding; Overview Of Forwarding Types - Siemens OpenStage 60 T Operating Instructions Manual

Basic functions
Step by Step
48

Call forwarding

If your belongs to an ONS group (parallel call
page 132), please note the following:
Call forwarding can be configured on any phone
in the ONS group and will then apply to all
phones in that ONS group.
Call forwarding between two phones in an ONS
group is not possible.

Overview of forwarding types

You have two options for programming call forwarding
on your station:
• „Configuring using the Program/Service
menu" page 51
• „Configuring using the call forwarding
key" page 49
The entries in the relevant menus correspond as ex-
plained in the following table:
Program/Service menu Forwarding key
FWD-VAR-ALL-BOTH on
All calls are forwarded, the saved phone number is de-
leted after deactivation.
FWD-FIXED on
All calls are forwarded, the saved phone number is
not deleted after deactivation.
FWD-VAR-ALL-INT on
Only internal calls are forwarded.
FWD-VAR-ALL-EXT on
Only external calls are forwarded.
FWD-VAR-BUSY-BOTH on
If your station is busy, all calls are forwarded.
FWD-VAR-RNA-BOTH on
If you do not answer a call, all calls are forwarded
ter a certain length of time.
FWD-VAR-BZ/NA-BTH on
If your station is busy or you do not answer a call, all
calls are forwarded after a certain length of time
[1] This duration is defined by your service personnel.
Apart from "Forwarding for intnl" and "Forwarding for
extnl", the forwarding types are mutually exclusive. You
can set and activate one forwarding desatination for
each of the two exceptions.
All calls
Fixed
Internal
External
Busy
No reply
Busy/no answer
[1]
af-
[1]
.