Download  Print this page

Audio I/o Module; Video Configurations For Different Models; Vio Module And Graphics Card; Svio Module - Philips epiq 5 Training Manual

Ultrasound.
Hide thumbs

Advertisement

For systems with version
14.1 software and later
this board is called the
AIO8 and contains the
iButton. See the
iButton
section if you should need
to replace this board.
12

Audio I/O Module

The Audio Input/Output Module (AIO) handles audio functions such
as CW and PW Doppler, microphone, physio beeps and PC generated
beeps. The audio processing such as volume control, filtering, mixing
and scaling occurs on the motherboard which delivers five different
audio streams. The AIO receives these via a USB bus from the
motherboard via the backplane.
Obtains three different supply voltages via the backplane: 3.3Vdc,
+5Vdc and 12Vdc.
 Has a USB hub for data input and output to the audio codecs.
 Contains PIC for power monitoring functions.
 Has three audio codecs:
1. Audio Codec with microphone input, outputs to DVD. (Right
channel only) Note: no playback capacity from DVD.
2. Audio Codec and two amplifiers that output to the system
monitor's two high frequency speakers.
3. Audio Codec and amp to subwoofer mounted above VPPM.

Video Configurations for Different Models

Depending on the version, EPIQ systems use the following different
video configurations:

VIO Module and Graphics Card

The VIO and graphics card were used on systems with SuperMicro
motherboards with software versions up to and including 1.2, and on
systems with BCM motherboards using software versions from 1.2.x
to 1.4. The system came standard with this video configuration. For
theory of operation, see the
manual.

SVIO Module

The SVIO Module replaced the VIO Module and the graphics card on
© 2016 Conquest Imaging
EPIQ 5 & 7 Training Manual
Video I/O Module
section of this

Advertisement

Table of Contents

   Related Manuals for Philips epiq 5

This manual is also suitable for:

Epiq 7

Comments to this Manuals

Symbols: 0
Latest comments: