Taillight Bulb Replacement
Take Qut the screws [AJ in the taillight lens .
Puillhe !ens off
Push the bulb in [AJ,lurn it counterclockwise , and pull it out.
Se sure the socket is clean
Insert the new bulb by aligning the pins [A] with the grooves in the
walls of the socket (8).
Push the bulb in. turn
It should lock in
Tighten the two screws. Be careful not to overtighten
Regulator Connector [A]
Unscrew the mounting bolts  and remove the regulator
regulator connector .
Set the hand tester x 1 kO range, connect it to the terminals in the
regulator connector, and check the resistance following the table.
ELECTRICAL SYSTEM 14-17