Busy Tone - Panasonic KX-HDV130 Manual

Tone Timings
Description
Value Range
Default Value
Configuration File Reference

4.6.6.2 Busy Tone

Tone Frequencies
Description
Value Range
Default Value
Configuration File Reference
Tone Timings
Description
Value Range
Default Value
Configuration File Reference
Document Version: 2017-07
Specifies the pattern, in milliseconds, of dial tones using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
Note
•
Avoid setting 1–50 for any of the values.
60,0
DIAL_TONE1_TIMING
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
Note
•
If the value for this setting is "480,620", the unit will use a
mixed signal of a 480 Hz tone and a 620 Hz tone.
480,620
BUSY_TONE_FRQ
Specifies the pattern, in milliseconds, of busy tones using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
0–16000 (0: Infinite time)
Note
•
Avoid setting 1–50 for any of the values.
60,500,440
BUSY_TONE_TIMING
4.6.6 Tone Settings
Administrator Guide 147